Вобщем поменяли датчики уровня передний и задний (были ошибки и не регулировался свет), всё заработало, но чел приезжает на следующий день и жалуется, что опять пищит табло, что свет не регулируется. Подключаю 431й и в 29 блоке (left light control) вижу эту ошибку 01539 Headlights not adjusted. Ессно она не стирается. Нарыл инфу по обучению блока на сайте ваг кома http://www.ross-tech.com
Xenon Headlamp Adjustment
Updated 29 Mar. 2005
Ross-Tech is not responsible for any damage or problems that may result from following these instructions. They are to be used at your own risk. As always, you should refer to a Factory Repair Manual for your vehicle!
This procedure details how to perform a Xenon Headlamp Adjustment on many VW/Audi vehicles equipped with Xenons (HID's). This procedure cycles the motorized headlamp adjusters to their center position so that the beams can be adjusted. This does NOT align the headlamps by itself. You still need to manually adjust the headlamps via the adjusting screws as referenced against a suitable aiming target.
If this procedure is only partially performed, there may be a DTC stored in the Xenon Range memory indicating "Headlights not adjusted". To clear this, you need to complete the entire procedure.
There are certain test conditions that must be met before doing this procedure:
• Vehicle must be parked on level ground and "settled" on its suspension
• Parking brake should be OFF
• Ignition should be in the "On" position
• Headlamps should be "Off"
________________________________________
Procedure for Aligning Xenon Headlamps:
[select]
[55 - Xenon Range] (For some newer vehicles, use [29 - Left Light] instead )
[basic Settings - 04]
Group 001
[Go!]
Wait at least 20 seconds for the headlamp motors to move. The headlamps are now in their adjustment position. Turn on headlights. Adjust them via their manual adjusting screws as referenced against a suitable aiming target.
Scroll up to Group 002. The Xenon Range controller has now learned this position as its Home position.
Click the [Done, Go Back] button and you're all set.
Note: There have been reports of lowered vehicles displaying an error message in either Basic Settings group 001 or 002. If the vehicle height sensor(s) are bottomed out, it may be necessary to bend the sensor bracket to allow normal adjustment to occur.
Вобщем с ланчем проделать эту процедуру у меня не получилось, при включении света постоянно рвет связь. KTSом конкуренты тоже не смогли. Отсюда вопрос может чтото в мануале написано не правильно или Ланч сука - неправильный? Возможно ли эту процедуру провести VAG-COM с USB-HEX-CAN адаптером или только к дилерам?