VW Sharan 2007г.

[Sergunja]

всем привет! на данном автосе висит не стираемая ошибка в АБС 00778 по датчику G85 - механическая неисправность. что интересно, в 4-й группе положение руля показывает корректно, без скачков, при ровном руле 0 град, как положено. пробовал в ведомых адаптировать G85, ВАС нахер посылает, типа нет ошибок, связанных с адаптацией. с питанием все в поряде. подскажите, что делать, приговаривать датчик?

[romykas]

s vag com pravedi basic seting info vzel s rosstech:

 

00778 - Steering Angle Sensor (G85): Mechanical Failure

 

Possible Causes

• Steering Angle Sensor (G85) Basic Setting lost
  
• Steering Angle Sensor (G85) Installation Position incorrect
  
• Suspension Geometry incorrect
  

Possible Solutions

• Perform Steering Angle Sensor (G85) Basic Setting
  
  • See Vehicle specific Diagnostic Procedures for Details
    

  [*]Check Steering Angle Sensor (G85) Installation Position

  [*]Check Suspension Geometry

 

 

 

[/url]

VW Sharan (7M) Brake Electronics (MK25)

 

 

 

 

 

Contents

[hide]

• 
  
• 
  
  • 
    

Coding

• ABS
  
  • 07177 = Standard
    

  [*]ABS/EDS/ASR/ESP

  • 06154 = Front-Wheel-Drive (FWD)
    
  • 06667 = All-Wheel-Drive (AWD)
    

 

Basic Setting

 

Sensor for Steering Angle (G85)

 

Prerequisites:

• Start the vehicle.
  
• Turn the steering wheel one turn to the right and one turn to the left (at least ± 15 ° each side).
  
• Drive in a short distance straight line on a level surface at a speed not higher than 20 km/h.
  
• If the steering wheel is straight during the test drive then stop the vehicle with the wheels pointed straight.
  
• Ensure that the steering wheel is not moved again.
  
• Keep the engine running and do not switch off the ignition.
  
• System voltage at least 12.0 V.
  

[select]

[03 - Brake Electronics]

[Coding-II - 11]

Enter 40168, to enable the basic setting.

[Do it!]

[basic Settings - 04]

Group 060

[Go!]

Activate the Basic Setting.

[ON/OFF/Next]

After a successful basic setting, field 2 should say "OK".

[Done, Go Back]

To make sure the basic setting was succesful, check the sensor again.

[Measuring Blocks - 08]

Group 004

[Go!]

Check field 1, the value has to be between -1.5 and +1.5 °.

[Done, Go Back]

[Close Controller, Go Back - 06]